FENDT CARAVAN 2021 Operation Manual page 68

7. Installation of electrical devices
Error
Error name
code
04
Mechanical
stop
05
On-board vol-
tage too low
No search
07
transponder
available.
Should these errors occur, the codes will appear in the display on the Kathrein control system. Please note that due,
to these errors, the satellite dish may in some cases switch itself off to prevent damage to the device. If possible,
remove the source of trouble before restarting the system. Never attempt to open or modify the equipment - this must
be done by an authorised Fendt dealer!
Problem
Long search times
Satellite not found/
no reception
Uncontrolled perfor-
mance of the turnable
satellite dish
These problems are not errors that will cause the system to stop and send an error message.
Therefore, they have no error code.
Causes
The dish has hit an obst-
ruction or is frozen.
Not enough power to ope-
rate the servomotors.
Antenna has lost its posi-
tion.
Electrical devices that
consume a great deal of
energy reduce the total
output.
Incorrect or manually mo-
dified channel list
Cause
The system is searching in
the wrong region.
The mobile home is loca-
ted outside the satellite's
footprint.
The turnable satellite dish
has "lost" the satellite and
cannot find it again.
Independent power supply
(model-specific / special accessory)
If your camper has been fitted with separate equipment or the autark
package by the manufacturer, please note the following:
In the nylon folder that contains the documents for the vehicle you
will also find the following operating instructions and connecting
diagrams:
- manufacturer's operating instructions for the multi-function
electrical supply / charger
Please read these important documents carefully to ensure that the
autark package functions correctly and efficiently.
To eliminate
Remove the obstruction; remove snow and ice from
the dish; restart the system.
Switch off other electrical devices. Charge the
battery.
Please have the satellite dish checked by a Fendt
dealer and let them install any updates.
Charge the battery and connect the 230V mains
connection.
Possibly switch off those devices (such as electric
heating elements) that consume a great deal of
energy.
Have the correct list installed. Your dealer can do
this.
Solution
Set the region in which the mobile home is loca-
ted (see Chap. 7, submenu: Set position).
Select another satellite.
Reset the system. The reset button is located on
the back of the
CAP 650.
64