FENDT CARAVAN 2021 Operation Manual page 84

8. Water
2
3
1
4
Plan for warm water supply
Emptying the therme:
• Switch off the electricity for the water pump by pressing the
l
of the main switch for 5 seconds.
control panel
• Open all faucets k
• Set all pre-mixing valves to "warm" if necessary.
• Open the drain valves
3 to 4 drain valves (depending on the layout/model) are directly
next to the therme; another 2 are on the opposite side.
• Check that the water is actually draining off.
• Close the runoff valve
line out).
Electric operation:
l
• Use the switch to turn on the therme. Use the thermostat to
regulate the water temperature to approx. 55° C.
• Power consumption: approx. 300 W.
Rules for the therme:
• Switch the device off when the caravan is not being used.
• Empty the therme at the risk of frost. Frozen water can cause
the therme to burst!
• A depressuriser must be used if the pump is connected to a
central water supply, or on stronger pumps. The pressure in the
therme may not exceed 1.2 bar. In addition, a safety valve or
j
runoff valve must be used in the cold water tap.
• We recommend that you do not use the water from the therme
as drinking water.
Never operate the therme electrically when it is empty.
WARNING:
The block circuit diagram only reflects the function.
Due to the various floor plans, individual modifications
are possible.
.
m
(tilting or rotating head).
m
after emptying (if necessary, blow the
80