Installation Of Electrical Devices; Safety Tips; Electrical Supply - FENDT CARAVAN 2021 Operation Manual

7.1 Safety tips

7.2 Electrical supply

3
43

7. Installation of electrical devices

The installation of electrical devices in the Fendt caravan have been
carried out in accordance with the valid regulations and norms.
Please note:
• Do not remove safety tips and warnings on the electrical equip-
ment.
• The installation spaces for electrical equipment such as distri-
bution fuse boards, electric power supply, etc., may not be used
as additional storage spaces.
• Only authorised specialists may work on the electric system.
• If the vehicle is equipped with a battery:
(special request / special accessory)
Only accumulators with bound electrolytes (Gel or AGM batte-
ries) may be installed.
• Turn off all equipment that uses 12 V before connecting or dis-
connecting the battery.
Electricity for the caravan can be obtained from the following
connections:
- 230 V mains connection 50 Hz.
- via the base vehicle if it is connected using the 13-pole plug
(limited functions)
- via a built-in auxiliary battery (not included).
Everything that uses 12 V, such as lighting, water supply, etc.,
is available
The 230 V system is protected by a two-pole 13 or 16 A automatic
circuit breaker
this include special installations such as ultraheat, hot-water heating,
etc. In this case, an additional two-pole 16 A overload circuit breaker
l
is installed.)
4
The residual current operated device must be checked regularly by
pressing the test button.
1
Supply via mains connection
The caravan receives its electric power supply via the 230 V CEE
feeder plug on the side wall of the vehicle.
To connect:
• Turn off the automatic circuit breaker
switch
• Grab the bottom of the protective cover
cket and flip it up.
.
m , which is located in the wardrobe. (Exceptions to
The bolted connections of the circuit breakers as well as
the secure fit of the connection cable must be checked
once a year by a specialist and, if necessary, tightened.
l
down.
m by pressing the rocker
j of the exterior so-