Completing The Hardware Installation - American Megatrends StorTrends 3100 Setup Manual

Completing the Hardware Installation

Next, you should check to make sure the peripheral drives and the Serial ATA drive have
been properly inserted and have not come loose in transit.
Step
1. Checking the drive
bays
2. Check the airflow
3. Connect your
network cable(s)
4. Connect your
keyboard and monitor
5. Supply power to the
system
6. Power your system
on
7. Get the IP address
12 StorTrends® 3100 Set Up Guide
Description
All drives can be accessed from the front of the server. Verify that
the hard disk drive trays are inserted all the way into its bay.
Airflow is provided by six high performance fans. The system
component layout was carefully designed to promote sufficient
airflow through the 3U rack mount space. Verify that all cables in
your rack are not obstructing the chassis's airflow.
Plug your Network Cable to both of
these ports or just one of them.
Plug your Keyboard Here
Plug your Monitor Here
The last thing you must do is to provide input power to the system.
Plug the three power cords from the power supply units into a high-
quality power strip that offers protection from electrical noise and
power surges. It is recommended that you use an uninterruptible
power supply (UPS).
Plug your Power into each of
these three power sockets.
American Megatrends StorTrends 3100
Once the StorTrends® Storage Appliance is fully operational, you
Power on by pressing this button.
!