Mounting The Ladder Rails With Transverse Profiles - OBO Bettermann SLM50 Mounting Instructions

6 3 2
Note!
SLM50 suspended vertical ladders for the maintenance of electrical function
Mounting vertical ladders up to a max storey height of 7 0 m

Mounting the ladder rails with transverse profiles

1. Draw the drill holes on next to the ceiling openings. Maintain the min-
imum edge spacing according to the approval of the anchor used.
2. Using a linear laser, transfer the position of the drill holes to the floor.
3. Pre-drill the drill holes. Ø according to anchor type and approval.
Fig 25: Mounting transverse profiles
4. Mount the U supports in parallel to the vertical ladder, each with 2
M12 anchors.
Fig 26: Mounting head plates
The threaded rods must be mounted at a spacing of y – x – y to each
other. x = vertical ladder width – 150 mm; y = 100 mm.
y y
x
23 | EN