Nailor ELECTRA-FLO G5 Operation And Maintenance Manual page 12

Configuration Menus
Main Menu Selection
Density Compensation
Select System of Units
Select Units of Measure
Flow Configuration
Display Configuration
Analog Output Configuration
Display Averaging Filter
Zero Lockdown
Alarm/Alert Configuration
Network Configuration
Field Characterization
Service Menu Selection
Password Configuration
Total System Scan
Sensor Enable/Disable
Sensor Data Scan
Sensor Alert Scan
Custom ID
Restore Factory Setting
Product Information
Configure Probes vs. Nodes
Main Menus System 1 and System 2 (Dual Channel Version Only)
Main Menu Selection
Density Compensation
Select System of Units
Select Units of Measure
Flow Configuration
Display Configuration
Analog Output Configuration
Display Averaging Filter
Zero Lockdown
Alarm/Alert Configuration
Field Characterization
Page 12
Nailor Industries Inc. reserves the right to change any information concerning product or specification without notice or obligation.
Select density compensation type for flow output (Actual or Standard CFM)
Select system of units (US or SI)
Select velocity and flow units
Select and configure flow and application parameter (ducted or fan inlet, duct size, fan inlet dia., etc.)
Set brightness and inactivity timeout interval
Configure analog output type, value and averaging filter
Configure display averaging filter
Adjust zero lockdown (below a FPM set point, drives display and output to zero)
Configure alarm type, upper and lower limits
Configure BACnet MS/TP or MODBUS RTU network connection
For information on field characterization, please see page 28.
Enable/disable and change password
Displays sensor enabled/disabled status
Enable or disable system sensors
Displays individual sensor data
Displays alert codes for each sensor
Configure ID (tag) of unit (also device name displayed in BACnet)
Restores display settings to original factory setup
Displays product information (Serial number, Work Order #, etc.)
Configure number of probes and sensors per probe
Select density compensation type for flow output (Actual or Standard CFM)
Select system of units (US or SI)
Select velocity and flow units
Select and configure flow and application parameter (ducted or fan inlet, duct size, fan inlet dia., etc.)
Set brightness and inactivity timeout interval
Configure analog output type, value and averaging filter
Configure display averaging filter
Adjust zero lockdown (below a FPM set point, drives display and output to zero)
Configure alarm type, upper and lower limits
For information on field characterization, please see page 28.
Description
Description
Description
3/21 IOM-ELECTRA-FLO-INST