Pattern Options: Fixed Or Variable Speed; Recording Patterns When Configured For 16 - American Dynamics SpeedDome Ultra VII EIS Operator's Manual Supplement

Pattern Options: Fixed or
Variable Speed
A Pattern is a series of programmed pan/tilt/zoom
dome movements. The SpeedDome Ultra VII with
EIS allows you to create fixed speed or variable
speed Patterns (variable speed Patterns are
dependent on system capability).
The SpeedDome Ultra VII with EIS provides three
options when configuring the system for Patterns:
Setting Description
Off Allows programming of three fixed speed
Patterns. The three Patterns are limited
to a total of 99 pan/tilt/zoom movements
(e.g., if one Pattern uses 50 movements,
the remaining two Patterns are limited to
a total of 49 movements). Note: The
VM96 system only supports the OFF
setting.
Allows programming of three variable
3
speed Patterns. Each Pattern can have
up to 99 pan/tilt/zoom movements.
16 Allows programming of 16 variable
speed Patterns. Each Pattern can have
up to 99 pan/tilt/zoom movements.
Use the following steps to configure the dome for
Patterns:
1. Enter the Dome Configuration Menu
(Figure 17.) by pressing Iris Open, Focus Far
and Zoom Out on your controller.
Figure 17.
DOME CONFIGURATION MENU
PAN / TILT / ZOOM / SYNC OPTS
CAMERA FUNCTIONS
ALARMS / AREAS / PRESETS / PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES
2. Use the joystick to highlight On-Screen Text
Display and press Focus Far to select. The
On-Screen Text Display screen appears
(Figure 18.).
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME CONFIGURATION UTILITY
OPERATOR'S MANUAL SUPPLEMENT
Figure 18.
ON-SCREEN TEXT DISPLAY
STATUS DISPLAY
DISABLE ALL NAMES?
DIAGNOSTIC DISPLAY
DIRECTION INDICATOR
PATTERN SELECT
NAME CONFIGURATION MENU
TEXT ATTRIBUTE OPTIONS
3. Use the joystick to highlight the PATTERN
SELECT field and press Zoom In/Out to select
Off 3, 16
, or
4. Use the joystick to highlight EXIT and press
Focus Far to select. The Dome Configuration
Menu appears.
5. Use the joystick to highlight EXIT AND SAVE
CHANGES and press Focus Far to save.
Recording Patterns When
Configured for 16
Recording Patterns when the Pattern Select field
is set for Off, 3, or 16 is accomplished through
keyboard commands (consult your keyboard's user
guide). However, additional steps are required
when the Pattern Select field is set for 16.
Follow the steps below to record 16 variable speed
Patterns:
1. Enter the appropriate keyboard commands to
record a Pattern, using 1, 2, or 3 as your
Pattern number (Consult your keyboard user
guide for specific steps.). The Pattern Select
screen appears (Figure 19.)
Figure 19.
PATTERN SELECT
1 5
1 6
3 7
4 8
7 of 15
OFF
YES
OFF
OFF
16
EXIT
.
9 13
10 14
11 15
12 16
EXIT
8200-0184-13, REV. A