American Dynamics SpeedDome Ultra VII EIS Operator's Manual Supplement page 5

Sequences are created by identifying Preset views
to include in the Sequence and specifying a dwell
time that controls how long each Preset remains on
screen before switching to another Preset. You can
create up to 16 Sequences, each with 16 steps
(Presets).
Steps to Programming
Sequences
Follow the steps below to program Sequences.
1. Access the Dome Configuration Menu
(Figure 10.) by pressing Iris Open, Focus Far
and Zoom Out on your controller.
Figure 10.
DOME CONFIGURATION MENU
PAN / TILT / ZOOM / SYNC OPTS
CAMERA FUNCTIONS
ALARMS / AREAS / PRESETS / PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES
2. Use the joystick to highlight Alarms / Areas /
Home / Presets/PZ and Press Focus Far to
select. The Alarms / Areas / Home / Presets /
PZ screen appears (Figure 11.).
Figure 11.
ALARMS/AREAS/HOME/PRESETS/PZ
SET ALARM ACTIONS
SET ALARM STATES
SET HOME POSITION
SET NORTH POSITION
AREA BOUNDARIES
PRIVACY ZONES
PRESETS
SCAN LIMITS
EXIT
3. Use the joystick to highlight Presets and press
Focus Far to select. The Select Preset to
Program screen appears (Figure 12.).
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME CONFIGURATION UTILITY
OPERATOR'S MANUAL SUPPLEMENT
Figure 12.
SELECT PRESET TO PROGRAM
PRESET
NUMBER
1-96
SEQUENCE SETUP MENU
CAMERA FUNCTIONS
FOCUS FAR to program preset
4. Use the joystick to highlight Sequence Setup
Menu and press Focus Far to select. The
Sequence Setup Menu screen appears
(Figure 13.).
Figure 13.
SEQUENCE SETUP MENU
SEQUENCE NUMBER 1
STEP 1-4
STEP PRESET
1 1
2 1
3 1
4 1
5. Use the Joystick to highlight the SEQUENCE
NUMBER field. Press Zoom In/Out to change
values (1-16).
6. Use the joystick to highlight the STEP field.
Press Zoom In/Out to scroll through available
steps. Steps are displayed in groups of 1-4, 5-
8, 6-12, and 13-16.
7. Use the joystick to highlight the PRESET field
and press Zoom In/Out until the desired
Preset number appears (1-96).
8. Use the joystick to highlight the DWELL TIME
MIN field and press Zoom In/Out until the
number of minutes you want the Preset to
remain on screen appears (0-10 minutes).
9. Use the joystick to highlight the DWELL TIME
SEC field and press Zoom In/Out until the
number of seconds you want the Preset to
remain on screen appears (0-60 seconds in
10-second increments).
10. Repeat steps 7 through 9 above until the first
four presets have been selected for steps 1-4.
5 of 15
PRESET NAME
PRESET 1-96
EXIT
DWELL TIME
MIN / SEC
0 0
0 0
0 0
0 0
EXIT
8200-0184-13, REV. A