Menu Programming Navigation; Setting Up Eis - American Dynamics SpeedDome Ultra VII EIS Operator's Manual Supplement

Menu Programming
Navigation
The SpeedDome Ultra VII with EIS is programmed
from on-screen menus that are accessible through
your controller (keyboard, virtual keyboard, or
®
Touch Tracker ).
The starting point for programming is the
Configuration Menu. To access the menu on
most controllers press and hold the following
buttons in sequence:
Iris Open > Focus Far > Zoom Out
(Consult your keyboard manual for instructions if
you are unable to access programming menu.)
When programming dome functions, the primary
methods of navigation, item selection, and value
increases or decreases are:
Joystick. The joystick allows you to move the
cursor—represented by highlighting—around the
menus. You can select a field when it is
highlighted.
Focus Far button. Pressing the Focus Far button
selects or enables a choice on a highlighted field.
Zoom In/Out button. Pressing the Zoom In/Out
button scrolls a pre-determined list of values either
up or down in a highlighted field.

Setting Up EIS

You can turn off EIS or adjust the EIS sensitivity
level for all SpeedDome VII EIS cameras on your
system through the Camera Functions screen.
Follow the steps below:
1. Access the Dome Configuration Menu
(Figure 1) by pressing Iris Open, Focus Far
and Zoom Out on your controller.
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME CONFIGURATION UTILITY
OPERATOR'S MANUAL SUPPLEMENT
Figure 1
DOME CONFIGURATION MENU
PAN / TILT / ZOOM / SYNC OPTS
CAMERA FUNCTIONS
ALARMS / AREAS / PRESETS / PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES
2. Use the joystick to highlight Camera
Functions and press Focus Far to select. The
Camera Functions screen appears (Figure 2).
Figure 2
CAMERA FUNCTIONS
Auto White Bal
IR MODE
EIS
AGC/Shutter
Open Shutter
RESET TO FACTORY SETTINGS
3. Make your desired changes. EIS settings
provide the following choices:
• 10 Hz = Default setting designed to stabilize
the dome when unwanted dome movements
are at 10 Hz.
• 5 Hz = Designed to stabilize the dome when
unwanted dome movements are at 5 Hz.
• Off = Turns off Electronic Image
Stabilization.
For further details on the Camera Functions
screen, consult Chapter 3 of the Day/Night
Camera Dome Configuration Utility Operator's
Manual, 8200-0184-04.
2 of 15
ON
Auto Low
10 Hz
Max Gain Limit
28 dB 1/4 s
EXIT
8200-0184-13, REV. A