How To Remove The Camera Assembly - American Dynamics SpeedDome Optima LT Installation And Service Manual

How to Remove the Camera
Assembly
Referring to Figure Chapter 3-8 .
!
WARNING!
Unexpected pan and tilt can cause injury
or damage the dome during servicing. To
prevent such movement, always
disconnect power/data connector P3
from the Unicard board before servicing.
1. Remove the lens and camera shrouds.
When removing the four screws from each shroud,
you may want to use a screwdriver with a magnetic
tip.
Note: It is not necessary to remove the eyeball
assembly to perform this task.
2. Detach cable connector.
On the camera/lens board, pull the tabs away from
the connector to release the cable from J1.
3. Remove the two screws that secure the
camera assembly to the eyeball casting.
Remove the two M3x10, Phillips head screws that
hold the camera/bracket assembly in place.
4. Reinstall the new camera (see list below),
reversing the steps above.
Camera/Bracket Assy
Lens Camera
1/4" Color, NTSC
1/4" Color, PAL
1/4" BW, EIA
1/4" BW, CCIR
!
WARNING!
Be careful not to bend pins on J1!
Carefully align camera cable before
inserting it into J1 on the camera/lens
board.
5. Reassemble the two shrouds using the eight
screws.
Part Number
0300-1754-01
0300-1754-02
0300-1754-03
0300-1754-04
SPEEDDOME LT
3-10
Figure Chapter 3-8. Removing the camera
assembly
Eyeball
casting
Camera/bracket
assembly
SERVICE
Cable
connects to
J1 on
camera /lens
board
M3x10 screws,
2 pl