American Dynamics SpeedDome Optima LT Installation And Service Manual page 24

!
WARNING!
Disconnect cable from power source
when performing cable conversions.
Figure Chapter 2-11. Patch cable connection
To Cinch-Jones
connector on composite
To video cable
BNC connector
4. If it is necessary to replace the Cinch-Jones
connector on the composite and video
cables, use the male and female BNC and
compression-type connectors supplied with
the SpeedDome Cable Conversion Kit (0351-
0403-01—Figure Chapter 2-12).
Use the following table and figure for data cable pin
out information.
Connector Pin Outs
Cinch-Jones (P2)
Pin No. Wire Color
7 Brown
8 Yellow
3 Black
4 Red
5 White
2 Green
1 Orange
Figure Chapter 2-12. Extending composite
cable
Male compression-type
connector, p/n 2109-
1
7
To existing
J-Box
cables
Female BNC connector,
p/n 2111-0034-01
To Unicard
terminal block,
P3
To Unicard BNC
connector, J1
Compression (P1)
Signal Name Pin No.
Data Out (Lo) 1
Data Out (Hi) 2
AC 3
Ground 4
AC 5
Data In (Lo) 6
Data In (Hi) 7
Female compression-
type connector,
p/n 2109-0254-06
1
7
To Unicard
Male BNC connector,
p/n 2111-0033-01
SPEEDDOME LT
INDOOR INSTALLATION
5. Set the dome address (Figure Chapter 2-13).
Using address switches (g), set the dome address
(Figure 2-13).
Figure Chapter 2-13. Setting dome address
Board edge
6. Lock the chassis into the housing.
Squeeze the ejector pins (h) and swing the chassis
all the way up, while easing the cables up through
the access holes. Release these pins into the
remaining corner receptacles.
!
WARNING!
Ejector pins must be fully inserted in
their receptacles.
2-9
MSB LSB
1 1 Video
SW2 SW1
J1
9 9