Table of Contents
Advertisement
For descaling the appliance we recommend the tried and proven agent:
To descale the appliance, perform the following steps:
– Fill the water tank with at least 3 or 4.5 l of fresh potable water.
– Add the sufficient amount of descaling agent to water (follow indications
on the packaging).
– Slide the riser pipe through the filter basket centre and place it in the
heating bowl, in the bottom of the water tank. Pay attention to correct
fitting of the riser pipe in the heating bowl.
– Place the lid on the water tank.
– Switch the appliance on with the ON/OFF switch.
– Perform the brewing cycle and leave the appliance on for approx. 15
minutes.
– Switch the appliance off.
– Use the drain tap to drain the descaling agent solution from the water
tank.
– After descaling, perform at least two brewing cycles with the use of fresh
EN
water, without ground coffee, to remove all remains of the descaling
solution.
– Rinse the tank, riser pipe and filter basket thoroughly with warm water,
and drain the water through the drain tap.
After descaling, the appliance may be switched on only after pressing the RESET
button, located at the bottom of the appliance.
During the subsequent start-up, the red malfunction indicator light will not come on.
20 / 24
Descaling agent B15-30, 30 pcs., art. No. 190065
Cleaning
A190149
Advertisement
Table of Contents
