The pin headers on the motherboard are often associated with important functions. With the shunt (Jumper)
pushed down on the designated pins (the pin numbers are printed on the circuit board, surrounding the pin
header), certain feature can be enabled or disabled. While changing the jumpers, make sure your system is
turned off.
Jumper Setting
To short the designated pins, push the jumper down on them so that they become SHORT. To make the
pins setting OPEN, simply remove the jumper cap.
2-pin Header
1
2
Open
Short
JCOM1:RTC reset
Pin
1-2 (Default)
2-3
SWJ6:RESET
Pin
1-2
2-3(Default)
ATPW1:AT/ATX Mode selection
Action
w/o Jumper(default)
w/ Jumper
J4:GEN3 LAY Bypass programming
Pin
1-2 (Default)
2-3
3-pin Header
1
2
3
Open
(1-2) Jumped
Description
Normal
Clear CMOS
Description
Hardware Reset
Software Reset
Description
ATX mode
AT mode
Description
Normal
Programming
19
4-pin Header
4
2
3
1
Open
(1-2) Jumped
1
2
3
1
2
3
1
2
3