Table of Contents
Advertisement
7.18 Other imagePRESS C6000 Main Unit Accessory Options
• Braille Label Kit-E1
• Voice Guidance Kit-A2
• Barcode Printing Kit-A1
• Key Switch Unit-A2
• ADF Access Handle-A1
• System Accessory Attachment Kit-A1
7.19 Notes on the Hard Disk
The imagePRESS C6000 has two hard disks to realize high-speed data transfer by
striping – a set of data is divided and written onto both hard disks simultaneously.
When turning the machine OFF, make sure to use the Control Panel Power Switch
on the operating console. For detailed instructions on shutting the machine down
properly, see Chapter 1, "Before You Start Using This Machine," in the Reference
Guide. Turning the machine OFF via the power switch may negatively impact the
performance and life of the drive.
If one of the two hard drives is damaged, it is necessary to replace both drives
because the imagePRESS C6000 system software is spanned over both drives.
Advise the user (administrator) to make a backup of important data (Inbox
contents) using the machine's user mode (administrator mode) periodically.
8.
Installation Review
8.1 Installation Time
The time required to install the imagePRESS C6000 depends on the options and
accessories to be installed, and the number of technicians performing the
installation. Customers should discuss the time requirements with their servicing
dealer and schedule the installation accordingly.
IMPORTANT
• Set up time may vary due to the following conditions:
- Forklift availability and its operator
- Narrow hallways, or a need to remove doors to enter rooms
- Uneven or damaged floors making leveling the equipment difficult and time
consuming
• With the aforementioned conditions in mind, an installation of only the main unit
can take between 4 to 6 hours. If accessories are included in the installation, the
times in the table below must be added.
Version 5
imagePRESS C6000 Customer Expectations Document
Page 36
Advertisement
Table of Contents
