Program Cat Activation; Program Auto Start - PetNovations CatGenie 120 Operation Manual

See Page 8 for info on PAUSING a CLEANING CYCLE and about POWER FAILURES
HOW OFTEN SHOULD I RUN
MY CATGENIE ON AUTO SET?
One Cat.......... Clean 2 times per day
Two Cats........
Clean 4 times per day
Three Cats.....
Clean 6 times per day
SHORT CUTS
Saves You a Setup Step
• Want to add more daily washes?
Just Press & Release the Auto Setup
Button at any time until the number
of cycles that you want lights.
• Want fewer daily washes? Press &
Release Auto Setup until all LEDs go
out. Then Press & Release Auto Setup
until your number of Cycles lights.
• Want to just change the wash time?
At the new time, Press & Hold Auto
Setup for 4 seconds then Release.
www.catGenie.com
ABOUT CAT ACTIVATION
With Cat Activation, the CatGenie cleans 10 minutes after your cat does his business.
If another cat needs to use the potty, the Unit resets and delays for another 10 minutes, etc.
The Unit will not start if a cat is using it. The Genie Eyes watch for that.
When set for CatActivation, the Cartridge switches from 120 doses of SaniSolution to 240 doses.
Because CatGenie cleans and flushes the mess immediately, it needs less Solution per wash.
Cat Activation uses two modes: 14 hours of Active Mode and 10 hours of Sleep Mode. In Active
Mode, the Unit cleans after cats use it. While in Sleep Mode, the Unit does not run. However you
can choose to press the Start Button to clean anytime during those 10 hours. When CatGenie
wakes up, it automatically cleans itself if any cat used it while it was sleeping.
HOW TO PROGRAM CAT ACTIVATION.
STEP 1.
Decide when you want the CatGenie to wake up from its 10-hour sleep.
That's the perfect time to do the following.
STEP 2.
Press & Release the Auto setup Button until the "CAT" LED lights up.
STEP 3.
Firmly PRESS & HOLD the Auto Setup Button for 4 seconds, then Release.
CAT LED.
Once set, your CatGenie responds with 3 Beeps and the CAT LED flashes on.
The Cat LED stays on as long as you have Cat Activation in Active Mode. The CAT LED blinks
fast for the 10 minute wait after cats use. In Sleep Mode, the Cat LED repeatedly blinks on and
OFF to indicate that the Unit is sleeping.
To DE-ACTIVATE
: Press & Release the Auto Setup Button until CAT LED goes out.
ABOUT AUTO START
With Auto Start, you preset the CatGenie to clean from 1 to 4 times during a 24 hour period.
Once programmed, the Unit automatically STARTS at the pre-set Cleaning Cycle times.
Because Auto Start runs on a timer, you would program your Auto Start Setup at one of the times
that you actually want your CatGenie to start a Cleaning Cycle. For example, if you want your
CatGenie to run at 2 am and 2 pm, you must program Auto Setup at either 2 am or 2 pm. If using
Auto Start, it is important to follow the chart at left and to observe when your cats do their business
so as to coordinate cleaning times.
HOW TO PROGRAM AUTO START SETUP.
STEP 1.
Decide how many times a day and what times of day that you want your
CatGenie to clean. Pick a time and do the following.
STEP 2.
To set the NUMBER of auto-timer washes (one to four) per day, Press & Release the
Auto Setup Button for EACH number of Cleaning Cycles that you want to run every day. For once
a day, Press & Release once. For twice a day, Press & Release twice. For three times a day, Press
& Release three times, etc. DON'T HOLD the button down.
A Daily Cycle LED lights for the each number of times set. One LED lights for once a day.
Two LEDs light for twice a day. Three LEDs light for three a day, etc. IF YOU MAKE A MISTAKE,
Press & Release the Auto Setup Button until all LEDs go out, then repeat Step 1.
STEP 3.
To set the TIMES that you want the CatGenie to run auto timer washes,
firmly PRESS & HOLD the Auto Setup Button for 4 seconds, then Release. CatGenie responds
with 3 Beeps while 4 Daily Cycles LEDs flash on and off, and then go out. The number of washes
you set stays lit. Once Auto is programmed, the CatGenie starts a cycle in 30 seconds.
CAUTION: It is important to run your CatGenie one to two times a day per cat.
Not running your CatGenie enough can cause clogs. Best to run a wash cycle
soon after your cats go. Don't let solids accumulate and harden.
7 1-888-735-3927