Catgenie Maintenance; Machine Cleaners; How To Clean The Water Sensor - PetNovations CatGenie 120 Operation Manual

CATGENIE MAINTENANCE

To keep your CatGenie running smoothly and to prevent problems like those seen
on pages 12 through 15, and on 17 and 18, take these simple precautions.
A. PUSH BUTTON MAINTENANCE
B. CLEAN WATER SENSOR
Gently Pull Out
Sensor
C. CHECK HOPPER
Keep Hopper
clear of cat hair, toys,
and foreign objects
like coins.
www.catGenie.com
How easy is this? Pop in the Machine Maintenance Cartridge.
Press the Start button and get a super clean, lime & grime free
CatGenie in places that you can't readily reach. Result, extra clean,
odor free, germ free deep inside your cat's bathroom. Ahhh, peace of
mind with a touch of a button. And a touch you do only four times a year.
Also available in Powder form in a Pouch. You have received a sample of one
or the other in your CatGenie package. Follow directions on the Cartridge or Pouch.
NOTE: By using the Maintenance Cleaners faithfully, you can skip Step B.
or do A and you'll never have to do B
Dirty Tip
is Dull
Clean Tip
is Shiny
to see what your cat dragged in.
If your cats have long or fuzzy fur, and/or your cats eat plastic, thread, string, or rug fabric,
it's important that you check the inside of the Hopper on occasion. These things can cause clogs.
Sometimes cats (and kids) drop objects into the Bowl, which can get scooped into the Hopper.
Toys, stuffed animals, coins, stones, all kinds of things have been found in Hoppers.
Remove the Hopper Cover. Look inside Hopper. If you see fur or something that doesn't belong, remove the
Processing Unit. Move the GenieHand down. Clear out the Hopper and clean the Water Sensor. See B, above.
Push Hand back up. Wipe off the Brim and bottom of the Processing Unit. Then put the Unit carefully back in its
place. It should Beep & Blink. If it doesn't, check if the power cord is plugged in. Make sure that the Processing
Unit is securely and completely placed in its slot.
Check the Genie WaterHose and DrainHose. Make sure they are not crimped, crushed, or
coiled too tightly. Correct to prevent clogs.
Finally, we recommend that you run a Cycle to make sure that the assembly is correct.
The Water Sensor TIP must be kept free of lime and mineral build up.
If you have hard water, it is important to clean it periodically. (Once every 3
months.) You can use the Maintenance Solutions (available at catGenie.com)
or do the following simple procedure. Keep power plugged and hoses in place.
Remove the Hopper Cover and pull the Processing Unit up and out of its slot.
Rest the Unit on a towel on the floor and lean it against the wall.
Grasp the Water Sensor Ends and gently pull up and out of the Base.
Have a towel soaked in lemon juice and/or use your finger to remove any lime
deposits and to make the TIP sparkle. Carefully slip the Sensor back into its slot.
Lower the GenieHand Check inside the Hopper. Remove fur and foreign
objects Before replacing the Unit, wipe away any Granules or debris off the Brim.
Raise the GenieHand to upright position. Place the Unit back into its slot.
It Beeps & Blinks. Your done. If it doesn't, check if plugged in. Make sure the
P-Unit is securely placed. Check that the hose and cord are in their groves.
16
TIP:
RUN ON
CAT ACTIVATION
Tests prove that CatGenie
performs 1O times
better on it than other
settings and requires
less maintenance.
See Page 7 for
setting.
1-888-735-3927