Use Rs-232 (Visca) - Bolin Technology 1 Series User Manual

Use RS-232 (VISCA)

You can use RS-232 port to connect to optional controllers, such as joystick control keyboard, control PC station, to
operate the camera.
To perform pan/tilt and zoom operations using the joystick of the control keyboard, and to perform the Preset operation
using the control buttons.
An application software that supports this unit is needed if you use PC station.
RS232 Connection
1. Set RS232 camera ID address (Default 1) in the camera OSD menu.
2. Set Baud Rate (Default 9600) in the camera OSD menu to the same Baud Rate as the Baud Raye set on the keyboard you are
using.
3. If you want to have the camera address to be automatically assigned by VISCA controller, set the camera address to 0.
4. Reboot the camera by turning it Off/On after the camera address and Baud Rate have been set up correctly.
5. Camera does not support Daisy Chain control.
6. The controller must be VISCA compatible.
7. Use the RJ45 to RS232 (VISCA) control cable. Or. you can make RS232 connection cable if you have the following
applications:
15