Table of Contents
Advertisement
Control the camera using HDBaseT Receiver
1.
Use one single CAT6 T-568B Standard Ethernet cable direct connect between the camera and the HDBaseT Receiver.
2.
HDBaseT carries up to 4K HDMI video signal, RS232/RS422/RS485 control signal, Audio, IR control signal, Power to the
camera.
3.
Set Baud Rate on the camera the same as Baud Rate set on the keyboard you are using.
4.
Reboot the camera by turning it Off/On after the camera address and Baud Rate have been set up correctly.
5.
Device supports RS232 and RS422/485 control.
6.
RS232 on HDBaseT receiver does not support daisy chain control.
7. Use Cat 6 network cable to connect the camera to HDBaseT Receiver.
HDBaseT RJ45 Connector pinout
Use Cat 6 network cable to make the RJ45 connectors to connect to the camera. RJ45 Connection instruction is
following:
14
Advertisement
Table of Contents
