Table of Contents
Advertisement
Power
•
Use only the DC power adaptor (power port type: YC8-4pin) supplied with the unit. Do not use any other DC
power adaptor.
•
Use POH Power Over HDBaseT to power up the camera. Use CAT5e/6 network cable connect the camera from
HDBaseT port and the HDBaseT receiver to run distance up to 100 meters over one cable.
•
Do not need to need to use the 12VDC power adapter for powering the camera when HDBaseT POH is being
used.
Cable Requirements
•
Network Cable: 10/100 Mbps Ethernet CAT
5/5E/6 UTP cables are applicable to the
ANSI/EIA/TIA-568A/B and ISO/D. Eight
wires in the network cable need to be inserted
in parallel into the top of the cable connector.
The cable connector needs to be crimped in
position. When the cable connector is in
position, ensure that the metal pieces of the
cable connector are parallel to each other and
the clamp of the cable connector is intact.
•
SDI Cable: For broadcast use,
Belden1694A/5CFB is a suitable cable to
transmit broadcast-quality video:
Conductor:
AWG
Stranding
18
Solid
Shield Material
Type
Layer
Tape
1
Braid
2
Nom. Capacitance
Conductor to shield
16.2 pF/ft
Material
Nominal Diameter
Bare Copper
0.04 in.
Material
Aluminum / Polyester / Aluminum
Tinned Copper
Nom. Inductance
0.106 µ H/ft
Coverage
100%
95%
Nom. Char. Impedance
75 Ohm
10
Advertisement
Table of Contents
