Table of Contents
Advertisement
Information of the camera initial setting status will display for 5 seconds.
1. Camera PELCO ID for RS-485 control
2. Camera VISCA ID for RS-422/232 control
3. Camera ID for IR Remote Controller
4. Baud Rate current setting
5. Control COMM Port current setting
6. Video format current setting
7. HDMI format current setting
8. SDI format current setting
9. Firmware version
Camera Control Methods and System Configurations
This unit has multiple ways of controlling the camera and various system configuration capabilities using optional
products. This section describes ways of controlling and typical system examples with the required components and usage
of each system.
1. Use the Infrared Remote Controller
2. Use RS-232 (VISCA)
3. Use RS-422/485 (PELCO P/D)
4. Use HDBaseT Receiver to control.
Control the camera without using HDBaseT Receiver
Use the Infrared Remote Controller
To operate the camera from a short distance. For IR remote control details, refer to Operation Using the Infrared Remote
Controller.
There are two IR receivers on the front side and back side of the camera for the camera control.
Via HDBaseT, you can use IR remote controller to control the camera from the remote side that is up
to 100 meters away.
Camera Status Info Display
PELCO ID
VISCA ID
IR ADDRES
BAUD RATE
HDMI FMT
SDI FMT
HDMI OUT
SV:
13
001
001
01
9600
1080P59.94
1080P59.94
RGB
S0E0500S35080AA07
Advertisement
Table of Contents
