Installing Ip Speeddome Ultra 8 With A Rhopn Pendant Mounting; Assembly Of The Rhopn Pendant Mount; Parts Supplied; Parts To Be Purchased - American Dynamics IP SpeedDome Ultra 8 Installation Manual

4 Installing IP SpeedDome Ultra 8 with a RHOPN

Assembly of the RHOPN Pendant Mount

Parts Supplied

• Support,10500-9641-01
• Cover, 10500-9588-01
• O-Ring, 12500-0022-07
• Screw, 20500-3494-01
• Retainer, 22852-0001-02
• Gasket, 10500-9801-01
• Install Kit, 0351-2119-01
• Anchor, M6, Wedge with hardware, 42880-0108-01
• Washer, Locking, M6 45846-0500-020
• Tee, 3.18cm, (1¼ in), 11417-0040-01
• Nipple, 3.18cm, (1¼ in), 11417-0041-01
• Flange, 3.18cm, (1¼ in), 11400-0069-01
• Screw, M3X12, 25801-1071-120
• Wrench, Tamperproof, Torx, 11400-0149-01
• Bushing, 11400-0047-01
• Connector, Liquid-Tight, 16010-0117-01
• Tape, Teflon, 1 roll, 3200-0229-01
• 6mm Drill Bit, 11400-0197-01

Parts to Be Purchased

• 3.2cm (1¼ in) galvanized steel pipe, NPT threaded at both ends. This part meets UL safety
standard UL 1950 up to a maximum length of 3m (10ft).
• 1.9cm (¾ in) conduit.

Tools Required

• Power drill
• Hammer
• Pliers
• Socket wrench kit with extension (metric)
Pendant Mounting
4-1