American Dynamics IP SpeedDome Ultra 8 Installation Manual page 33

At this stage you should prepare the SDU8 Camera for connection to the pendant housing.
Note
The SDU8 Camera's default physical address is set to 001 and should not need to be changed. If
this address is changed then you should ensure that a record of the new address is kept. During
the software installation ensure the dome configuration address is updated to match the domes
physical address via the Live Video page on the Web GUI in order for camera control to be
maintained. To change the SDU8 physical address, refer to SpeedDome
Operator's Guide 8200-0600-01.
16 Gently swivel eyeball to totally expose one of two slot covers.
Caution
Swiveling the eyeball fast can damage gears.
17 Insert small, thin-bladed screwdriver into space between cover and eyeball.
18 Gently pry off slot cover.
19 Gently swivel eyeball to totally expose remaining slot cover. With other cover removed, this
cover can be easily removed.
Note
The desiccant bag is only required for outdoor installations. If you are installing in an indoor
position then go to step 18
20 Place the desiccant bag in the pocket located inside the housing and adjacent to the
blower/heater assembly.
Figure 5-11 Removing the slot covers
Installing IP SDU8 with a ROENDC End Cap
®
Ultra 8 Camera Dome
5-5