American Dynamics IP SpeedDome Ultra 8 Installation Manual page 21

8 Repeat for its other end (A).
9 Tightly wrap a length of tape clockwise over the outside threads of bushing (C).
10 Tightly wrap a length of tape clockwise over the liquid-tight connector (D).
11 Thread nipple (A) into the flange.
12 Thread pipe tee (B) into the nipple.
13 Connect bushing (C) into the pipe tee (B).
14 Connect the liquid-tight connector (D) into the bushing (C).
15 Cut two 30cm (12in) lengths of Teflon tape.
16 Holding straight pipe (F) so that you are looking into its threaded end, tightly wrap a length of
tape clockwise over threads so it conforms to the threads.
17 Tightly wrap a length of tape clockwise over threads so it conforms to the threads of the straight
pipe's (F) other end. Insert straight pipe (F) into pipe tee (G).
18 Slip cover (A) over the straight pipe (F), then thread the support (B) onto the pipe (F).
Installing IP SpeedDome Ultra 8 with a RHOPN Pendant Mounting
G
H
Figure 4-3 Assembly of Pendant mounting
A
B
Figure 4-4 Attaching the housing
F
F
4-3