American Dynamics IP SpeedDome Ultra 8 Installation Manual page 31

Gasket (seat in groove
at bottom of opening)
Figure 5-4 Weatherproofing the End Cap assembly
4 Run cables from the existing pipe through the end cap and out its front.
5 Install the end cap as follows:
a Align arrow on the adapter pipe with the mark at the top of the pipe assembly.
b Maintaining arrow/line alignment, insert the End Cap assembly over the pipe until the
rubber sleeve on the adapter pipe meets the circumference mark.
Note
To ensure a good seal on the mounting structure it is recommened that you tighten the setscrews
evenly and do not overtighten them.
c Tighten the two setscrews using the Allen wrench.
Note
If marks on the pipe of the mounting structure are missing, scribe a circumference mark 4cm
(1.57in) from the end of the pipe.
Figure 5-5 Aligning the End Cap assembly
Figure 5-6 Inseting the End Cap assembly
Figure 5-7 Tighting the setscrews
Installing IP SDU8 with a ROENDC End Cap
Rubber Seal (seat
over opening)
Setscrew (2)
5-3