Pro:centric Setup - LG 22LY560M Commercial Mode Setup Manual

Pro:Centric Setup

Pro:Centric options enable you to configure the TV with the
appropriate settings to connect to the Pro:Centric server. Use the
Up/Down arrow keys on the Installer Remote to navigate between
fields.
1. With the IP Environment Menu on display, use the arrow keys
on the Installer Remote to select Pro:Centric. Then, press OK.
Note: Options that are initially grayed out/inaccessible in the
Pro:Centric Menu are dependent upon other settings in the
display. For example, if "IP" is selected in the Media Type field,
the Server IP and Port Number fields become accessible.
2. Refer to the appropriate subsection(s) below to configure the
TV's Pro:Centric settings to match those of the Pro:Centric
server.
While the Pro:Centric application (Mode) itself is an additional
feature, the appropriate Pro:Centric server configuration must
be completed to enable TV E-Z Installation (splash screen,
configuration, and/or firmware) data downloads and, if
configured, the Pro:Centric application download.
Note: For those fields that permit direct entry of numerical
values (for example, Server IP, Port Number, Data Channel,
etc.), once you key in the maximum number of digits allowed in
the highlighted field, the next available field will be highlighted.
RF Configuration
a) In the Media Type field, use the Left/Right arrow keys to select RF.
Note: If the Media Type has already been set in the Express Script
Installer Menu Wizard, the specified value will be reflected in this field.
b) In the Data Channel field, either key in or use the Left/Right arrow keys
to select the RF channel number that will be used by the Pro:Centric
server as its data channel. The Data Channel value can be set from 0
(disabled) to 135. *
For TVs in Pass-through Mode or FTG Mode, if this item is left at its
default value (255), the TV's Data Channel Auto Search feature will be
enabled. See Installer Menu item 119 DATA CHANNEL description on
page 30 for further information.
Note: If the Data Channel has already been set in the Installer Menu
(Installer Menu item 119) or in the Express Script Installer Menu Wizard,
the specified channel will appear in this field. If you change the Data
Channel in this menu, Installer Menu item 119 will now show the value
you entered here.
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
206-4261
IP Environment Setup (Cont.)
IP Environment
IP Environment
• Network Connection
Mode
• Network Status
Media Type
• Pro:Centric
Server IP
• MAC Address: CC:2D:8C:87:8B:70
Port Number
Data Channel
Update Event
Update Time
Move OK
Move OK
0ff
RF
0 0 0 0
0
255
Off
12 AM 00
Close
(Continued on next page)
59