Table of Contents
Advertisement
(Continued from previous page)
If the network is connected successfully, a "Connected to Internet"
message will appear just below the progress display. If the network
connection is not successful, the progress display will identify the
network element in which the connection failed. Check your cabling
and/or verify the configuration data, as necessary.
6. Once the wired network configuration is complete, use the arrow keys
on the Installer Remote to return to the IP Environment Menu, as
necessary, or press
and/or exit the IP Environment Menu.
Pro:Centric Setup
Pro:Centric options enable you to configure the TV with the appropriate
settings to connect to the Pro:Centric server. Use the Up/Down arrow
keys on the Installer Remote to navigate between fields.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select the Pro:Centric menu option. Then,
press OK.
2. Select/highlight the Media Type field and press OK on the Installer
Remote to display the drop-down list of options. Then, use the Up/
Down arrow keys to select either RF or IP, as applicable.
Note: If the Media Type has already been set in the EZ-Manager
Wizard, the specified value will be reflected in this field.
3. Refer to the appropriate subsection(s) below to configure the TV's
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application itself is an additional feature (see
step 4), the appropriate Pro:Centric server configuration must be
completed to enable TV E-Z Installation (boot logo, configuration,
and software) data downloads and, if configured, the Pro:Centric
application download.
RF Configuration
For TVs in Pass-through Mode or FTG Mode, if the Data Channel is
left at its default value (AUTO), the TV's Data Channel Auto Search
feature will be enabled. See Installer Menu item 119 DATA CHANNEL
description on page 44 for further information.
• To change the Data Channel setting, select/highlight the Data
Channel field and press OK on the Installer Remote. Then, use
the Up/Down arrow keys to select either MANUAL or AUTO from
the drop-down list of options.
206-4351
to return to the previous Network Menu level(s)
IP Environment Setup (Cont.)
PRO:CENTRIC
Network
Pro:Centric
Mode
Configuration Only
Update Event
Update Time
2:00 AM
Media Type
RF
Data Channel
AUTO
Note: By default, the Pro:Centric Menu
initially shows RF configuration fields.
When "IP" is selected as the Media Type,
Server Address, IP Type, IP Address, and
Port Number fields appear on the screen
(in place of the Data Channel field).
^
^
^
^
(Continued on next page)
63
Advertisement
Table of Contents
