Table of Contents
Advertisement
IP Environment Setup (Cont.)
Pro:Centric Setup
Pro:Centric options enable you to configure the TV with the appropriate
settings to connect to the Pro:Centric server. Use the Up/Down arrow
keys on the Installer Remote to navigate between fields.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select the Pro:Centric menu option. Then,
press the Wheel (OK) button.
2. Select/highlight the Media Type field and press the Wheel (OK) button
on the Installer Remote to display the drop-down list of options. Then
use the Up/Down arrow keys to select either RF or IP, as applicable.
Note: If the Media Type has already been set in the EZ-Manager
Wizard, the specified value will be reflected in this field.
3. Refer to the appropriate subsection(s) below to configure the TV's
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application itself is an additional feature
(see step 4), the appropriate Pro:Centric server configuration must
be completed to enable TV E-Z Installation (configuration and soft-
ware/firmware) data downloads and, if configured, the Pro:Centric
application download.
RF Configuration
For TVs in Pass-through Mode or FTG Mode, if the Data Channel is
left at its default value (AUTO), the TV's Data Channel Auto Search
feature will be enabled. See Installer Menu item 119 DATA CHANNEL
description on page 47 for further information.
To change the Data Channel setting, select/highlight the Data Channel field
and press the Wheel (OK) button on the Installer Remote. Then, use the Up/
Down arrow keys to select either MANUAL or AUTO from the drop-down list
of options.
When the Data Channel field is set to "MANUAL," a data entry field is
available on the screen, and you can specify the RF channel number that will
be used by the Pro:Centric server as its data channel. The Data Channel value
can be set from 0 (disabled) to 135.
Remote to select the Data Channel data entry field and press the Wheel (OK)
button. You can then use the number keys on the Installer Remote to direct
enter the Data Channel, or you can use the arrow keys to select the appropriate
number(s) from the pop-up virtual keyboard displayed at the bottom of the
screen. When you are done, select Enter from the virtual keyboard, and then
press the Wheel (OK) button on the Installer Remote.
Note: If the Data Channel has already been set in the Installer Menu (Installer
Menu item 119) or in the EZ-Manager Wizard, the specified channel will appear
in the Data Channel data entry field. If you change the Data Channel in this
menu, Installer Menu item 119 will now show the value you entered here.
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
70
* Use the arrow keys on the Installer
PRO:CENTRIC
Network
Pro:Centric
Mode
^
Configuration Only
Portal Settings
Update Event
Update Time
^
2:00 AM
Media Share
Media Type
^
RF
Data Channel
^
AUTO
Note: By default, the Pro:Centric Menu
initially shows RF configuration fields.
When "IP" is selected as the Media Type,
Server Address and either IP Address
and Port Number or Domain Name and
Port Number fields appear on the screen
(in place of the Data Channel field).
(Continued on next page)
206-4335
Advertisement
Table of Contents
