Pro:centric Setup - LG ProCentric 55UV560H Commercial Mode Setup Manual

Pro:Centric Setup

Pro:Centric options enable you to configure the TV with the appropriate
settings to connect to the Pro:Centric server. Use the Up/Down arrow
keys on the Installer Remote to navigate between fields.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select the Pro:Centric menu option. Then,
press OK.
2. Select/highlight the Media Type field and press OK on the Installer
Remote to display the drop-down list of options. Then use the Up/
Down arrow keys to select either RF or IP, as applicable.
Note: If the Media Type has already been set in the EZ-Manager
Wizard, the specified value will be reflected in this field.
3. Refer to the appropriate subsection(s) below to configure the TV's
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application itself is an additional feature (see
step 4), the appropriate Pro:Centric server configuration must be
completed to enable TV E-Z Installation (splash screen, configuration,
and software/firmware) data downloads and, if configured, the
Pro:Centric application download.
RF Configuration
For TVs in Pass-through Mode or FTG Mode via CPU, if the Data
Channel is left at its default value (AUTO), the TV's Data Channel Auto
Search feature will be enabled. See Installer Menu item 119 DATA
CHANNEL description on page 39 for further information.
To change the Data Channel setting, select/highlight the Data Channel
field and press OK on the Installer Remote. Then, use the Up/Down
arrow keys to select either MANUAL or AUTO from the drop-down list
of options.
When the Data Channel field is set to "MANUAL," a data entry field is
available on the screen, and you can specify the RF channel number
that will be used by the Pro:Centric server as its data channel. The
Data Channel value can be set from 0 (disabled) to 135.
Use the arrow keys on the Installer Remote to select the Data Channel
data entry field and press OK. You can then use the number keys on
the Installer Remote to direct enter the Data Channel, or you can use
the arrow keys to select the appropriate number(s) from the pop-up
virtual keyboard displayed at the bottom of the screen. When you are
done, select Enter from the virtual keyboard, and then press OK on
the Installer Remote.
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
206-4326
IP Environment Setup (Cont.)
*
PRO:CENTRIC
Network
Pro:Centric
Mode
^
Configuration Only
Update Event
^
Disable
Media Type
^
RF
Data Channel
^
AUTO
Note: By default, the Pro:Centric Menu
initially shows RF configuration fields.
When "IP" is selected as the Media Type,
Server Address and either IP Address
and Port Number or Domain Name and
Port Number fields appear on the screen
(in place of the Data Channel field).
(Continued on next page)
57