Operation; Main Switch; To Start The Product; Operating Mode Start - Gardena SILENO+ Operator's Manual

4.1 Main switch

WARNING:
instructions carefully before you start the
product.
WARNING:
away from the rotating blades. Do not put
your hands or feet near to or below the
product when the blade motor is on.
WARNING:
when persons, especially children, or
animals are in the work area.
• Set the Main switch in the
product.
• Set the Main switch in the
product is not in use or before you do inspection or
maintenance on the product.

4.2 To start the product

1. Push the STOP button to open the hatch.
2. Set the Main switch to position
3. Enter the PIN code.
4. Push the START button.
5. Select the desired operating mode and confirm
with the OK button. Refer to
on page 29 .
1378 - 005 - 17.09.2020

4 Operation

Read the safety
Keep your hands and feet
Do not use the product
1 position to start the
0 position when the
1 .

Operating mode Start

6. Close the hatch.
Note:
If the product is parked in the charging station,
the product only leaves the charging station when the
battery is fully charged and if the schedule allows the
product to operate.
Note:
The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.
4.3 Operating mode Start
Push the START button to select the following operating
modes:
Main area
•
Secondary area
•
• Override schedule
Spot cutting
•
4.3.1 Main area
Main area is the standard operating mode where the
product mows and charges automatically.
4.3.2 Secondary area
To mow secondary areas the operating mode
Secondary area must be selected. In this mode, the
operator must move the product manually between the
main area and the secondary area. The product mows
for a selected period of time or until the battery is empty.
When the battery is empty, the product stops and the
Needs manual charging shows in the product
message
display. Put the product in the charging station to charge
the battery. When the battery is charged, the product
moves out of the charging station and stops. The
product is now prepared to start operation, but needs
confirmation from the operator first. In the
area mode, the product operates for a selected period of
time or until the battery is empty.
Note:
If you want to cut the main area after the battery
is charged, set the product to
you put the product in the charging station.
4.3.3 Override schedule
The schedule settings can be temporarily overridden by
Override schedule . It is possible to override the
selecting
schedule for 24 h or 3 days. It is not possible to cut more
than the maximum cutting time per day.
Secondary
Main area mode before
Operation - 29