Page 1
TAIT T500 METER CONVERTION INSTRUTIONS FROM G0WFQ QTHR ON QRZ.COM...
Page 2
Test Equipment needed for the conversion 1. Multimeter (e.g. Analogue) 2. DC electronic voltmeter (e.g. Digital) 3. RF Power meter 30 watts FSD usable to 100mhz with 5 and 30 watt elements 4. Power supply output adjustable between 9 and 16 volts DC and with a capacity of at least 5 amps 5.
Page 3
VCO and this can be done very ease as well what you will need for this is your power supply and volt meter and dummy load and power meter. When operating the Tait on frequencies below 150MHz, connect C204 (2p7) in circuit by shorting the pads of LK-1 RX Alignment Connect power supply the radio making sure of the polarity before turning on.
Need help?
Do you have a question about the T500 and is the answer not in the manual?
Questions and answers