Vimar 02952 Installer Manual page 13

Thermostat
Communication objects and ETS parameters
Continued
No. ETS name Function
108 NOT USED
109 General Alarm
110 Input Input
111 Input Status Input
112 On/Off Relay
113 Status Relay
114 Value Humidity
114 Value Humidity
115 Setpoint shift increase Setpoint
116 Setpoint shift decrease Setpoint
(*) This datapoint is only available starting from firmware version 2.00 and later.
Number of communication objects
109
Description
Used for viewing, on the thermostat display, the trigger-
ing of a generic alarm on the KONNEX BUS
Device IN control
Device input status. It appears if the input is set as
"general use" and "Toggle rising/falling edge"
Device relay control (setting relay operating parameters
as "general use")
Device relay status (setting relay operating parameters
as "general use")
To know and view the humidity read by a KNX probe
connected to the bus
To know and view the humidity read by a KNX probe
connected to the bus (*)
To control an increase equivalent to "setpoint shift step"
of the current current setpoint (setpoint set by ETS on
the thermostat for the various operating modes CMF,
STBY, etc.). The temperature shift permitted is limited to
the range set by the parameter: Guest Control Permitted
To control a decrease equivalent to "setpoint shift step"
of the current current setpoint (setpoint set by ETS on
the thermostat for the various operating modes CMF,
STBY, etc.). The temperature shift permitted is limited
to the range set by the parameter: Guest Control Per-
mitted.
Max. number of group addresses
254
Flag 1
Type
C R W T U
1 bit C R - T -
1 bit C R - T -
1 bit C - W -
1 bit C - W -
1 bit C R - T -
1 byte C - W -
2 byte C - W -
1 bit C - W -
1 bit C - W -
Max. number of associations
255
Priority
I
- Low
- Low
U - Low
U - Low
- Low
U - Low
U - Low
U - Low
U - Low
13