Download Print this page
Rockler Indexing Dado Instructions Manual
Rockler Indexing Dado Instructions Manual

Rockler Indexing Dado Instructions Manual

Advertisement

Quick Links

Indexing Dado Jig Instructions
Effective July 2020
Review full instructions prior to use for important safety information.
Always check Rockler.com to confirm that you are using the most recent version of instructions for your product.

Advertisement

loading
Need help?

Need help?

Do you have a question about the Indexing Dado and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Rockler Indexing Dado

  • Page 1 Indexing Dado Jig Instructions Effective July 2020 Review full instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent version of instructions for your product.
  • Page 2: General Safety Warnings

    This product is designed only for specific applications as defined in the instructions and should not be modified or used for any manner not described in these instructions. Use only recommended accessories. Before using the Indexing Dado Jig: READ, UNDERSTAND and FOLLOW ALL INSTRUCTIONS AND SAFETY WARNINGS. KEEP THESE INSTRUCTIONS READILY AVAILABLE FOR FUTURE REFERENCE.
  • Page 3 > ALWAYS remove the router bit from the router BEFORE mounting the router to the Router Plate (1). > The Indexing Dado Jig works with 1/8"-diameter router bits and 1/4"- through 3/4"-diameter router bits. It does NOT work with bits between 1/8" and 1/4" in diameter.
  • Page 4 PARTS LIST Quantity Router Plate Jig Base Adjustable Fence Easy-to-Grip 3/4" Round Knob Small Compression Washer #8-32 x 5/8" Machine Screw Easy-to-Grip 1" Knob Large Compression Washer 5/16"-18 x 1 ⁄ " T-Bolt ROUTER MOUNTING SCREWS (NOT SHOWN) Quantity 10 M5-0.8 x 5/8" Flathead Screw 11 M4-0.7 x 5/8"...
  • Page 5 Offset Keys Fig. 1 Fig. 2 Assembly and Calibration > ALWAYS remove the router bit from the router BEFORE mounting the router to the Router Plate (1). 1. If the Router Plate (1) is attached to the Jig Base (2), loosen and remove the two Easy-to-Grip 1”...
  • Page 6: Setup And Use

    Router Plate (1) > BEFORE beginning any routing operation, ALWAYS on the Jig Base (2). make sure that ALL knobs on the Indexing Dado Jig have been tightened. 3. Loosen the two Easy-to-Grip 1" Knobs (7) holding the Router >...
  • Page 7 Adjustable Fence. Fig. 6. the just-cut dado to guide the cutting of subsequent dadoes. Check Rockler.com for updates. If you have further questions, please 11. Turn the jig back around to its original orientation and contact our Technical Support Department at 1-800-260-9663 position it so the bit is off to the side of the test piece or support@rockler.com...
  • Page 8 59237 Distributed by Rockler Companies, Inc. 1-800-279-4441 Rev 07/20 4365 Willow Dr. Medina, MN 55340 www.rockler.com...

This manual is also suitable for:

59237