Break In Service - 10 Hours - MacDon FD1 FlexDraper Manual

Draper clinic handout
Hide thumbs Also See for FD1 FlexDraper:
Table of Contents

Advertisement

Break In Service
50 Hours – Continued
Change knife drive box lubricant.
Check side draper deck height adjustment.
NOTE: Correctly setting side draper deck height will limit the amount of material getting in between the drapers.
This should prevent stalling and damage to side drapers.
8 Draper Clinic Handout - FD1 FlexDraper
Raise the header and place a container large enough to hold approximately
2.2 liters (2.3 quarts) under the knife drive box to collect the oil.
Remove the breather/dipstick (A) and the drain plug (B). Alternate drain plug
located on forward side of the box. Drain the oil and replace the plug.
Add 2.2 liters (2.3 quarts) SAE 85W-140 to the knife drive box.
Refer to Section 5.9 Knife Drive System in the Operators Manual
for more information.
Check that clearance (A) between draper (B) and cutterbar (C) is 1–3mm
(1/16 - 1/8 in). If not, rotate connector slat to topside, loosen tension on
side draper, grab draper at connector slat and lift up and rearward to
remove draper from under cutterbar and expose the deck support.
Prop draper up with bar. Measure and note the thickness of the draper belt.
Loosen the two lock nuts (D) on the deck support (A) one-half turn only.
Tap the deck (A) to lower the deck relative to the deck supports. Tap the
deck support beside nuts (D) using a punch to raise the deck relative to
the deck supports.
Adjust so that measurement (B) is the thickness of the draper plus 1mm
as measured previously.
Tighten hardware then reinstall and tension draper. Recheck gap
to confirm correct adjustment.
Refer to Section 5.12 Header Side Drapers in the Operators Manual
for more information
®

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FD1 FlexDraper and is the answer not in the manual?

Table of Contents