Table of Contents
Advertisement
Setup
Programming ON Duration
on:Pr, on:CY or on:ti appears on the display identifying
the function being programmed (see below).
The LED illuminates below the related symbol on the
controller to indicate the active function.
NOTE: Selection on:Pr, on:CY or on:ti designates the
way the pump run time is controlled:
•
on:Pr - Pressure Control,
reaching a specific pressure
threshold measured by an
external pressure switch
•
on:CY = Cycle Control,
completing a specific number of
cycles of an external prox/cycle
switch
•
on:ti = Time Control, a specific
duration of time elapses
Pressure Control (on:Pr) ON Setup
1. Use the UP or DOWN arrow
button until on:Pr displays.
2. Press the ENTER button.
3. Pressure control is an ON / OFF
selection only. After pressing the
ENTER button, the controller saves the Pressure
Control information and moves to setting Backup
Time, page 15.
14
Cycle Control (on:CY) ON Setup
1. Use the UP or DOWN arrow
button until on:CY displays.
2. Press the ENTER button.
The first number displayed after the
on:CY is entered, blinks. This indicates the device is
ready to program the number of cycles.
NOTE: The cycle entry is a 2-digit number. Enter a
leading zero (0) in the first field if the number of cycles is
fewer than 10.
3. Program the cycles by pressing the UP or DOWN
arrow button to move up or down through the
numbers 0 to 9.
4. When the correct first digit is displayed, press the
ENTER button.
The cursor automatically moves to the second number
field and flashes. Use the UP or DOWN arrow button to
scroll through the numerals 0 to 9 until the desired num-
ber appears in the second cycle number field.
5. Press the ENTER button. After pressing the ENTER
button, the controller saves the Cycle Control
information and moves to setting Backup Time,
page 15.
Time Control (on:ti) ON Setup
1. Use the UP or DOWN arrow
button to cycle through until on:ti
displays.
2. Press ENTER.
3A2960G
Advertisement
Table of Contents
