Shifting
Shifting cables will stretch during the wear-in period. This may affect
shifting performance and the derailleur may need to be adjusted.
Hardware
All hardware should be torqued to the torque specified in the
Recommended Torque Values section of this manual. Refer to the
table of contents at the beginning of this manual for the page number
of this section. If any hardware has signs of damage take the bike to
your local bike shop to have a certified and reputable bike mechanic
inspect and replace them if deemed necessary.
Ongoing Service
You should have your bike maintained at regular service intervals
at your local bike shop by a certified and reputable bike mechanic.
Below is a general summary of maintenance that should be carried
out on a monthly and quarterly basis:
Monthly (or about every 250-500 miles)
•
Inflate tires to a pressure within recommended range printed
on tire sidewalls.
•
Lubricate chain such that there is minimal noise from the
drivetrain when in use.
•
Check that all hardware is tightened to the torque
specifications listed in the Recommended Torque Values
section of this manual. Refer to the table of contents at the
beginning of this manual for the page number of this section.
•
Check your brake pads for signs of wear. Replace if necessary.
•
Check your bike's shifting performance. Adjust the derailleur
if necessary.
•
Clean the bike with low residue cleaner and dry completely.
Lubricate after cleaning where necessary.
•
Check spoke tension. Adjust if necessary. The recommended
spoke tension can be found in the Recommended Torque
Values section of this manual. Refer to the table of contents at
the beginning of this manual for the page number of
this section.
M A I N TA N I N G YO U R B I K E
6
Need help?
Do you have a question about the XP 2.0 and is the answer not in the manual?
Questions and answers
When I turn the key the bike does not turn on
The Lectric XP 2.0 bike may not turn on when the key is turned due to several possible issues:
1. Battery Charge: The battery may not be sufficiently charged. Ensure the battery is fully charged until the light on the charger turns green.
2. Key Position: The key might not be in the correct position. Insert the key into the battery and turn it counterclockwise to the "ON" position or until it is parallel with the frame.
3. Display Connection: There could be a connection issue with the display. Follow the cable from the display to the quick plug, unplug it with a quick pull (without twisting), inspect both sides of the plug, and reconnect it properly.
If these steps do not resolve the issue, contacting customer support is recommended.
This answer is automatically generated
I’m having a problem with unfolding the bike. I can only open the lever to a 45 degree angle. I’ve tried machine oil and WD40. It seems that the “open” button on top doesn’t work properly. **** I doing something wrong or is this a common problem?
The context does not explicitly mention a common issue where the Lectric XP 2.0 bike's lever only opens to a 45-degree angle. However, it does mention that the folding latch should be adjusted properly so that it is not too tight, allowing it to be opened when needed. If the lever does not fully open, it may be due to over-tightening or improper adjustment of the latch.
This answer is automatically generated
Is there a reset **** for the lcd
Yes, the odometer on the Lectric XP 2.0 can be reset by holding the plus button for 5 seconds. However, there is no mention of a full LCD reset option.
This answer is automatically generated