Table of Contents
Advertisement
This will ensure that the motor will not activate until the display is
turned back on and the rider is ready to go.
( Note: Exercise extreme caution using the twist throttle. When
at a complete stop with the bike turned on, be careful not to
twist the throttle unknowingly or the bike could throw you off
balance and cause serious harm, injury, or death.)
13. To turn on the headlight and tail light, press and hold the plus
button on the button pad. The battery must be inside the bike
Use caution to not engage walk mode unknowingly.
This mode is engaged by holding the minus button
FRONT AND REAR LIGHTS
The Lectric XP comes with fully integrated front and rear lights.
Lectric eBikes strongly recommends using these lights when riding at
night or in low visibility situations. To turn the lights on, hold the plus
button on the display control pad until the lights turn on. To turn the
lights off, repeat.
WALK MODE
In general, electric bikes are heavier than their non-electric
counterparts. This makes walking the bike a more strenuous activity.
To make walking the bike easier, the Lectric XP is equipped with
walk mode. If you hold down the minus button on the display control
pad, the motor will engage at a speed similar to a slow walk. When
walk mode is engaged, a "Walk" indicator will appear on the display.
To deactivate walk mode, simply pull the brake levers to engage the
motor inhibitors or press and hold the minus button. Walk mode can
be toggled on or off in the settings menu. See the Display Settings
section of this manual for instructions.
YO U R F I R S T R I D E
on the display control pad and will engage the
motor up to a walking speed.
24
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the XP 2.0 and is the answer not in the manual?
Questions and answers
When I turn the key the bike does not turn on
The Lectric XP 2.0 bike may not turn on when the key is turned due to several possible issues:
1. Battery Charge: The battery may not be sufficiently charged. Ensure the battery is fully charged until the light on the charger turns green.
2. Key Position: The key might not be in the correct position. Insert the key into the battery and turn it counterclockwise to the "ON" position or until it is parallel with the frame.
3. Display Connection: There could be a connection issue with the display. Follow the cable from the display to the quick plug, unplug it with a quick pull (without twisting), inspect both sides of the plug, and reconnect it properly.
If these steps do not resolve the issue, contacting customer support is recommended.
This answer is automatically generated
I’m having a problem with unfolding the bike. I can only open the lever to a 45 degree angle. I’ve tried machine oil and WD40. It seems that the “open” button on top doesn’t work properly. **** I doing something wrong or is this a common problem?
The context does not explicitly mention a common issue where the Lectric XP 2.0 bike's lever only opens to a 45-degree angle. However, it does mention that the folding latch should be adjusted properly so that it is not too tight, allowing it to be opened when needed. If the lever does not fully open, it may be due to over-tightening or improper adjustment of the latch.
This answer is automatically generated
Is there a reset **** for the lcd
Yes, the odometer on the Lectric XP 2.0 can be reset by holding the plus button for 5 seconds. However, there is no mention of a full LCD reset option.
This answer is automatically generated