Installation Of The Product - Husqvarna 550H EPOS Operator's Manual

3.8 Installation of the product

3.8.1 General steps for installation of the
product
For full instructions follow the installation instructions in
Installation of the product on page 15 .
1. Install the reference station.
2. Install the charging station.
®
3. Install the Automower
mobile device.
4. Pair the product with the Automower
app. Do the basic settings in the start up sequence
®
in the Automower Connect app.
5. Make a map with work areas, stay-out zones,
transport paths and point of interests.
®
6. Use Automower Connect app to do settings for
the product.
3.8.2 Installation tools
• Hex key, 8 mm. Included in the carton.
3.8.3 Installation of the charging station
Read and understand the instructions about the
charging station. Refer to To examine where to put the
charging station on page 12 .
WARNING:
about electrical safety.
WARNING:
used with the power supply unit supplied by
Husqvarna.
WARNING:
supply at a position where there is a risk that
it can become wet. Do not put the power
supply on the ground.
WARNING:
power supply. Condensed water can harm
the power supply and increase the risk of
electrical shock.
WARNING:
Install only to an residual-current device
(RCD) with a tripping current of maximum 30
mA when connecting the power supply to
the wall socket. Applicable to USA/Canada.
If power supply is installed outdoors: Risk of
Electric Shock. Install only to a covered
Class A GFCI receptacle (RCD) that has an
1619 - 002 - 19.01.2021
Connect app to your
®
Connect
Obey national regulations
The product is only to be
Do not put the power
Do not encapsulate the
Risk of Electric Shock.
enclosure that is weatherproof with the
attachment plug cap inserted or removed.
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
and extension cable must be outside the
work area to avoid damage to the cables.
When connecting the power supply, only use a power
outlet that is connected to an residual current device
(RCD).
3.8.3.1 To install the charging station
1. Put the charging station in the selected area.
2. Attach the charging station to the ground with the
supplied screws.
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in. Refer to To examine where to put the
power supply on page 13 .
min 30 cm / 12"
5. Connect the power supply cable to a 100-240V
power outlet.
6. Put the low-voltage cable in the ground outside the
work area. Use stakes or bury the cable.
7. Put the product in the charging station to charge
the product.
3.8.3.2 To do a visual check of the charging station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
The power supply cable
Installation - 15