Table of Contents
Advertisement
7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
•
Obey all applicable national regulations.
•
Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.
7.2 Storage
•
Fully charge the product. Refer to
battery on page 24 .
•
Disconnect the product with the Main switch. Refer
To switch off the product on page 24 .
to
•
Clean the product. Refer to
page 25 .
•
Keep the product in a dry, frost free space.
•
Keep the product with all wheels on level ground
during storage, or use a Husqvarna wall hanger.
•
If you keep the charging station indoors,
disconnect and remove the power supply from the
charging station.
Note:
If you keep the charging station outdoors, do
not disconnect the power supply and the connectors.
7.3 Disposal
•
Obey the local recycling requirements and
applicable regulations.
•
For questions about how to remove the battery,
To remove the batteries on page 37 .
refer to
7.3.1 To remove the batteries
CAUTION:
Only remove the batteries
when you dispose the product. When you
remove the warranty seal, the Husqvarna
warranty is no longer applicable.
1.
Disconnect the product with the Main switch. Refer
to
To switch off the product on page 24 .
2.
Pull out the grommet on the charging cable at the
very front of the product, and carefully remove the
connector.
3.
Lift the cover, one corner at a time.
4.
Remove the 14 screws with a Torx 20.
1619 - 002 - 19.01.2021
To charge the
5.
6.
Clean the product on
7.
8.
9.
Lift the rear edge of the top section of the chassis.
Disconnect the cable from the main circuit board.
Remove the top section of the chassis.
Remove the 3 screws that holds the batteries with
a Torx 20.
Disconnect the batteries connection from the main
circuit board.
Transportation, storage and
disposal - 37
Hide quick links:
Advertisement
Table of Contents
