To Examine Where To Put The Power Supply - Husqvarna 550H EPOS Operator's Manual

• If the product must not operate in a part of the
docking area, put a protective wall that is minimum
15 cm / 6 in. in height. The docking area (A) is a
circular area around the charging station with a
radius of 3 m / 9.8 ft.
Note:
The product uses the charging station
signal to search for the charging station when it is
in the docking area.
• Put the charging station near a power outlet.
• Put the charging station on a level surface.
• The baseplate of the charging station must not be
bent.
max. 5 cm / 2"
max. 5 cm / 2"
1619 - 002 - 19.01.2021
•
3.6 To examine where to put the power
supply
A
•
•
•
Low-voltage cables of different lengths are available as
accessories.
If the work area has 2 parts separated with a steep
slope, we recommend to put the charging station in
the lower section.
CAUTION:
Metal objects in the ground,
for example reinforced concrete or anti-mole
nets can cause interference with the
charging station signal.
WARNING:
Do not cut or extend the
low-voltage cable. There is a risk of
electrical shock.
CAUTION:
Make sure that the blades
on the product do not cut the low-voltage
cable.
CAUTION:
Do not put the low-voltage
cable in a coil or below the charging station
plate. The coil causes interference with the
signal from the charging station.
Put the power supply in an area with a roof and
protection from the sun and rain.
Put the power supply in an area with good airflow.
Use a residual-current device (RCD) with a tripping
current of maximum 30 mA when you connect the
power supply to the power outlet.
Installation - 13