Husqvarna 550H EPOS Operator's Manual page 28

Message
No loop signal
Outside work area
28 - Troubleshooting
Cause
The power supply or the low-voltage ca-
ble for the charging station is not connec-
ted.
The power supply or the low-voltage ca-
ble for the charging station is damaged.
ECO mode is enabled and the LED indi-
cator lamp on the charging station is
flashing green. The product has been
started manually in the work area without
pushing the STOP button before remov-
ing the product from the charging station.
The charging station signal is disabled
and the product cannot enter the charg-
ing station. Refer to ECO mode on page
21 .
The product does not find the loop signal
from the charging station.
The charging station in not installed cor-
rectly.
Interference from metal objects such as
fences, reinforcement steel or buried ca-
bles near the charging station.
The work area slopes too much by the
virtual boundary.
The transport path or the path to the
point of interest slopes too much.
The product finds it hard to distinguish
the charging station signal from another
product installation close by.
Interference from metal objects such as
fences, reinforcement steel or buried ca-
bles near the charging station.
Action
Examine the LED status on the charging
station. If there is no power to the charg-
ing station, the LED is not lit. Examine
the wall socket connection and if a resid-
ual-current device is engaged. Make sure
that the low-voltage cable is connected to
the charging station.
Replace the power supply or low-voltage
cable.
Put the product in the charging station.
To start the
Start the product. Refer to
product on page 23 .
Put the product in the charging station
and generate a new loop signal. Refer to
New loop signal on page 21 .
Install the charging station according to
To install the
the instruction. Refer to
charging station on page 15 .
Change the position of the charging sta-
tion.
Make sure that the virtual boundary is in-
To examine
stalled correctly. Refer to
where to install the objects on the map
on page 14 .
Make sure that the transport path is in-
To install the
stalled correctly. Refer to
map objects in a slope on page 14 .
Put the product in the charging station
and generate a new loop signal. Refer to
New loop signal on page 21 .
Change the position of the charging sta-
tion.
1619 - 002 - 19.01.2021