Husqvarna 550H EPOS Operator's Manual page 29

Message
Empty battery
No drive
Wheel motor overloaded
right, left
Charging station blocked
Stuck in charging station
Upside down
Mower tilted
Lifted
Collision
1619 - 002 - 19.01.2021
Cause
The product cannot find the charging sta-
tion.
The battery is at the end of its life cycle.
The charging station's antenna is defec-
tive.
The product has hit an obstacle and
stopped or the wheels cannot move on
the wet grass.
The work area includes a steep slope.
Grass or other objects is wound around
the drive wheel.
The contact between the charging strips
and contact strips may be poor and the
product has made a number of attempts
to charge.
An object is obstructing the product.
The charging station is tilted or bent.
The product slips on the baseplate.
There is an object in the way of the prod-
uct preventing it from leaving the charg-
ing station.
The product is leaning too much or has
turned over.
The product is tilted more than the maxi-
mum angle.
The lift sensor is engaged because the
product hit an object or/and is blocked.
The body of the product can not move
freely around its chassis.
The product has become stuck.
Action
The product has no accurate position
and cannot find the charging station.
There is an obstacle preventing the prod-
uct to find the charging station.
Replace the battery. Refer to
page 26 .
Check if the indicator lamp in the charg-
ing station flashes red. Refer to
cator lamp on the charging station on
page 34 . This problem requires action
by authorized service technician.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Maximum guaranteed slope is 45%.
Steeper slopes should be isolated. Refer
to To install the map objects in a slope
on page 14 .
Examine the drive wheel and remove
grass or other objects.
Put the product in the charging station
and check that the charging plates and
contact plates make good contact.
Remove the object.
Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not be
tilted or bent.
Clean the baseplate.
Remove the object.
Turn the product the right way up.
Move the product to a flat area.
Free the product. If the problem stays,
speak to your approved servicing dealer.
Remove dirt or objects between the
chassis and the body to make sure that
the body can move freely around the
chassis.
Free the product and rectify the reason.
Troubleshooting - 29
Battery on
LED indi-