Table of Contents
Advertisement
This winch has a capacity of 3,500 lb applying this measurement to practical application; you
•
can use this winch to move the following.
Move a load from a dead stop of up to 3,500 lb, on level ground;
◦
move a water bourne craft of up to 9,500 lb;
◦
maintain movement of a wheeled vehicle of up to 11000 lb.
◦
Pulling capacity is reduced as incline increases. For example, rolling capacity is reduced from
•
6,000 lb on flat ground to 1100 lb on a 45° incline. Please refer to the following chart for estim-
ated pulling capacity (rolling weight) on various inclines. Please use the block and tackle
Using the emergency hand crank
Warning: Do not use the crank to assist an operating winch. This will damage the winch and
may cause personal injury.
1. Turn the clutch knob clockwise until hand tight. Do not force it or over tighten.
2. Place the end of the hand crank over the flattened end of threaded shaft on the left side of the
winch.
3. Rotate the hand crank clockwise to tighten the cable. Continue to turn until the cable has been
completely retracted.
Maintenance
1. Lubricate the cable occasionally with light oil.
2. Grease the gears every 6 months. To do this, remove the clutch knob and separate the left
and right housing. Use any good quality waterproof grease.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61000–61002, 61769
Page 8
11 2020-1
Advertisement
Table of Contents
