Table of Contents
Advertisement
14. Avoid unintentional starting. Be sure that you are prepared to begin work before turning the
start switch on.
15. Stay alert. Watch what you are doing. Do not operate this machine when you are tired.
16. Do not operate this machine while under the influence of alcohol, drugs, or prescription
medicines.
17. Check for damaged parts. Before using any tool, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and
any other condition that may affect proper operation. Any part that is damaged should be
properly repaired or replaced by a qualified technician. Do not use the tool if any switch does
not turn on and off properly.
18. Replacement parts and accessories. When servicing, make sure service personnel use only
identical replacement parts. Use of any other parts will void the warranty. Only use parts and
accessories intended for use with this tool.
Special warnings when using this electric device
Using this powerful tool may create special hazards.
Take particular care to safeguard yourself and those around you.
Cable
Be sure the cable is in good condition, and is attached properly.
•
Do not use the winch if the cable is frayed.
•
Do not replace the cable with a cable of lesser strength.
•
Battery
Be sure the battery is in good condition. Avoid contact with battery acid or other contaminants.
•
Always wear approved eye protection when working around a battery.
•
Have the engine running when using the winch, to avoid running the battery down.
•
Stand back
Stay out of the direct line that the cable is pulling. If the cable slips or breaks, it will "whiplash"
•
along this line.
Keep hands, clothing, hair and jewelry clear of the winch while in use.
•
Use a spotter to assist you in assuring that it is safe to operate the winch. Make sure this per-
•
son is out of the way of the vehicle and the cable before activating the winch.
Power limits
Do not attempt to exceed the pulling limits of this winch.
•
Never use the hand crank to "assist" the winch. This will damage the winch and may cause
•
personal injury.
Installation
Wiring your Electric Winch
Your Winch may be used with temporary wiring or permanent wiring
Temporary Wiring
1. Lift the rubber seal, and power cable plug into the socket on the right side of the winch body.
Route the power cable from the winch to your battery, being careful to avoid tangling it in mov -
ing equipment, or causing a tripping hazard.
2. Connect the black clamp handle of the power cable to the frame of your vehicle, establishing a
ground connection. Connect the red clamp handle to the positive (+/red) terminal of your bat-
tery. Note: Be sure you are using a 12 V automotive battery or equivalent, in good con-
dition.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61000–61002, 61769
Page 5
11 2020-1
Advertisement
Table of Contents
