Installation Instructions - Scosche MagicMount UQ01 Manual

Modification Required Proceed with CAUTION!
Use the Illustration for demonstration use only. Vehicle disassembly/ modification may vary
per installation/vehicle.

INSTALLATION INSTRUCTIONS

1. Select a mounting location (A).
2. Route the provided power harness to the nearest 12V power (B).
3. Disassemble panels to gain access to the selected 12V connector.
4. Test the modules functionality by connecting the provided t-harness to the power source
and the type-c connector to the module (C), diagram on page 5.
5. Custom-make a slot for the bezel to settle in (template on page 7) and create a hole large
enough to pass the type-c connector through, if necessary (D).
Recommended: Use the provided two-sided adhesive to hold the bezel in place (clean
area before placing adhesive).
6. Reassemble everything in reverse order of your disassembly to complete the installation
and place the Qi-enabled device on the charging surface (E).
ASSEMBLY
6