Access - Fermax MILO Installer Manual

Access

DOOR RELAY TIME: Time for lock-release relay remains active (option 1-9 s).
DOOR DELAY TIME: Is the time lasted between the moment in that the open door order has
been sent and the moment in that the realy is activated. Open door relay is useful when the
door is quite far from the panel. (option 0-9 s)
DOOR ALARM: An alarm will trigger if the door keeps opened after the programmed DOOR
ALARM time. Options: disable, 30s. 60s. 120s, 180s and 250s.
DOOR FORCED ALARM: An alarm will trigger when an abnormal way to open the door has
been detected, for example because there has not been any previous open the door command.
EXT. UNLOCK: Activates or deactivates the additional relay performance (*)
Relay 1-4. DOOR RELAY TIME: Time that the corresponding additional door relay keeps active
(1-9 s optional).
Relay 1-4 OPEN DOOR REALY: Delayed time lasted between the unlock order and the
activation of the corresponding relay. This parameter is useful when the door is not close the
panel (0-9 s optional).
ADMIN CARD.: Wiegand CODE of the ADMIN card, that will later be useful for programing
another user cards.
Default value (0000) causes that the first card presented on the reader becomes into the ADMIN
card, so if there is still no intention of create an ADMIN card it is mandatory to change this value
for any other (for example 1234).
DISARM BY CARD: When an already programmed user card is presented to the reader, and
it has been previously assigned to a monitor, the alarm system of the corresponding apartment
wich change to HOME mode.
GUEST CODE: Not available in this version.
WIEGAND: Protocol used for Wiegand transmission (BURST or 26 BITS)
FACILITY: Not available in this version.
ACCESS PIN: Enable or disable the access by means of a PIN code.
Up to 8 different PIN code for each panel.
Length of the PIN between 4 and 6 digits.
(*) REMARKS: The additional relay module F01491 (4 relays module) shall be connected to
the port RS485 in the panel Nº of the BLOCK.
Page 15