Table of Contents
Advertisement
Safety
Note!
The machine must only be lifted using the lifting eye intended for the purpose
in accordance with the relevant instructions.
Note!
The machine should be stored in a dry, warm (plus degrees) location when not
in use.
Note!
If the machine is stored in a cold area (below zero), it must be kept in a warm
area (above zero) for at least two hours before use.
Note!
When dry grinding, a suitable dust extractor should be used. For available
models of dust extractors, go to HTC's website
more information.
Note!
The dust extractor's suction hose must be connected to the appropriate socket
on the machine. Adjust the dust extractor to match the grinder's capacity.
Note!
Do not use the emergency stop switch to stop the machine, except in
emergencies.
Note!
As long as the emergency stop switch is pressed in, the machine cannot be
started. Reset by turning the switch 45° clockwise so that it pops out again. The
machine can then be restarted.
Note!
After removing glue and wet grinding, always lift up the grinding heads so that
they do not stick to the floor and damage machine components and the floor
when restarting.
Note!
When wet grinding, the water tank must be filled with water. Only use cold
water with no chemical additives.
8
HTC 650 HDX
www.htc-floorsystems.com
for
3.0
Advertisement
Table of Contents
