Board; Required Equipment/Tools; Replacement Of Mac Address Label - Sony SRG-300SE Service Manual

2-2. SY-437 Board
When replacing the SY-437 board, perform the following procedure.
Otherwise, a trouble such as being unable to obtain the IP address in DHCP occurs, and this unit does not
operate normally.
. Replacement of MAC address label (Section 2-2-2)
. Confirmation of model name/MAC address and writing of serial number (Section 2-2-3)
. Firmware version upgrade (Section 2-2-4)
If the version upgrade is not performed, this unit may not operate normally.
n
As for the SY-437 board, the parts to be replaced vary between SRG-300SE and SRG-301SE. Replace the
parts required for each model. (Refer to Section 5.)

2-2-1. Required Equipment/Tools

. PC
t
For the operating environment, refer to "Required system configuration" in the User's Guide
. LAN cable
. SDI monitor
t
Prepare the 3G-SDI compatible monitor.
Prepare the 3G-SDI level A mapping.
. BNC cable
. 12 VDC power supply
. Latest updating firmware
t
Japanese site: http://www.sony.jp/brc/support/
English site: https://pro.sony.com/bbsc/ssr/cat-camerasptz/
. Latest SNC toolbox
. MAC/Serial writing tool: J-7121-430-A
n
Install the SNC toolbox and MAC/Serial writing tool according to Section 2-1-2 in advance.

2-2-2. Replacement of MAC Address Label

Replace the MAC address label attached to this unit with the MAC address label supplied with the new
SY-437 board.
SRG-300SE/301SE
2-9 (E)