2-2-3. Confirmation of Model Name/MAC Address and Writing of Serial Number
Preparation
1. Connect the devices as follows.
LAN cable
PC
2. Change the IP address of PC according to Section 2-1-3.
3. Turn on the power of each device and wait until the image is output on the SDI monitor.
4. Start the SNC toolbox and check that the model information is displayed.
If it is not displayed, click the [Search] button.
The screen shows an example of SRG-300SE.
5. Double-click G6SerialInputforService.exe.
G6 Serial_Inputter For Service is started.
2-10 (E)
BNC cable
This unit
[START] button
SDI monitor
[Search] button
Model information display
SRG-300SE/301SE