Confirmation Of Line Input - Sony SRG-300SE Service Manual

2-3-3. Confirmation of LINE Input

Procedure
1. Connect the devices as follows.
LAN cable
PC
2. Perform the following CGI command according to Section 2-1-5 to change the audio setting.
CGI command: http://192.168.0.100/command/camera.cgi?MicLineSelect=line
User name: Administrator user name (default: admin)
Password: Administrator password (default: admin)
3. Reproduce the sound using the audio output device, and adjust the sound output level so that it is in
the range from 0.5 to 10.0 V p-p using the oscilloscope by referring to the illustration below before
inputting the sound to this unit.
Connect to the tip of the oscilloscope probe.
Connect to GND of the oscilloscope probe.
RCA pin jack
4. Input the sound to this unit.
5. Check that the sound is output from PC and that the audio level meter of this unit extends.
End
1. Reset this unit to the factory setting according to Section 2-1-6.
2. Turn off the power of each device and disconnect the connections.
SRG-300SE/301SE
BNC cable
This unit
Oscilloscope
SDI monitor
Audio cable
(connected to LINE IN
terminal)
Audio output device
(PC, amplifier, player, etc.)
2-19 (E)