Connecting The T/H Sensor Monitoring Cable - Huawei ECC500 User Manual

ECC500
User Manual

4.3.1 Connecting the T/H Sensor Monitoring Cable

Context


Procedure
Step 1 Prepare an RJ45 connector on one end of a network cable, as shown in
Figure 4-13 Preparing an RJ45 connector (unit: mm)
Step 2 Prepare an RJ12 connector on the other end of the cable, as shown in
Figure 4-14 Preparing an RJ12 connector (unit: mm)
Step 3 Plug the RJ45 connector to an RS485 port with 12 V power supply in the ECC500 and the
RJ12 connector to the RS485 port in the T/H sensor.
----End
Issue 03 (2020-01-06)
When connecting a T/H sensor to the ECC500, perform the following steps to prepare a
special monitoring cable.
The cable connection method described in the section applies to cable connections from
the ports of the RS485 expansion card in the ECC500 to devices.
Copyright © Huawei Technologies Co., Ltd.
4 Installation and Commissioning
Figure 4-13.
Figure 4-14.
38